I’ve been dreading the assembly of the appliance garage for a while, since it involves precision routing, both straight and curved. Had to bite the bullet, it was time.
The straight bits were easy, I clamped a guide to the panel and routed against that. The rounded bits were done very carefully, by hand. I slipped a few times, but the lip on the channeling is wide enough to hide small mistakes.
The completed right hand side. The way this unit is designed is that it gets a wrapped panel on either side, just like my other cupboards. And this raised a dilemma. If I hang the cupboard doors on the top “third” of this unit, they would hang in front of the side panel (If this doesn’t make sense, never mind, trust me). Point is, it won’t look good.
So I routed the thickness of a door off the front edge of the top “third”.
See?
If this plugpoint ever breaks, the poor bugger won’t be able to get it out (the nuts will just spin). Not Right, but expedient (this plugpoint at the top left hand corner of the middle “third”.